what to do after booting up first time computer

Quick navigation:

• What does information technology means to kick computer?

• If your computer is a desktop

• If your calculator is a laptop

What does it ways to kick computer?

Reckoner booting ways a process of starting a computer with operating organization installed on it. During the booting process, it will load some software in main memory (also called ransom access retentivity ) required to beginning Windows by hardware or firmware (MBR or UEFI) in the CPU. Allow'southward look at the booting process in details.

First, press the power button of a estimator to start upwards the power supply.

Next, the basic input-output organization(BIOS) on the read-simply memory(ROM) volition be loaded, and information technology volition starting time to check if all the hardware is working properly, the process is also called ability-on self test(Mail service).

Then, the BIOS will outset to notice the bootable device through the boot sequence and boot loader or volume boot record (VBR) on the agile master partition, usually located in the outset 512-byte sector.

After that, the kicking loader or VBR will initial and execute the operating organisation boot loader files, such as, io.sys, ntldr, bootmagr, to load the operating system and its kernel, arrangement drivers, applications, or commands required for the boot process.

Finally, But wait the file loading procedure, then you will see a boot screen including all the data of the computer and a prompt to enter the BIOS setup. Set the right boot society in BIOS to start your computer.

Dissimilar BIOS, UEFI does not rely on boot sectors, UEFI system loads the .efi files of kicking loader directly, and the Os kernel is loaded by the boot loader.

The boot procedure looks complicated, doesn't it? Not really, because your computer volition perform all the operations automatically in the groundwork before you come across the kicking screen. Then, the rest is only a piece of cake. Bank check them in the following.

If your computer is a desktop

Step ane. Completely shutdown your desktop estimator, otherwise the deejay may be burn out. Then, install the new deejay on the actress bulldoze bay using screwdriver, information technology can exist a cloned/restored drive, or freshed installed deejay.

Step 2. Click the power button to restart your computer.

Footstep 3. Then, you lot may see a black screen with words like "Windows is loading files...". Just wait until you meet the way to enter BIOS, press the specific key, it's usually F11, f1, F2, F8,F9, f10, ESC, DEL etc.

Step four. Your figurer will enter the legacy BIOS if the destination disk is a MBR deejay, and you will see several tabs at the elevation. Go to the Boot tab and set the new hard drive every bit first boot choice in Legacy Boot Pick Priority option or similar option.

Step five. Save changes and reboot your reckoner to access the desktop. Then, cheque if all your content are intact.

If your computer is a laptop

Unlike the booting process of desktop computer, laptop volition be a little tricky, considering virtually of them only have i bulldoze bay. Therefore, you lot need to swap hard drive in laptop with new hard bulldoze first, it can exist a cloned/restored hard drive or fresh installed deejay, then boot but similar a desktop calculator.

Stride 1. Completely shutdown your estimator, and open the laptop back panel to access your hard drive.

Footstep 2. unscrew the screws belongings hard drive in the computer and put them into a safe instance, and so you can easily go them later.

Step 3. Take out the old hard drive at a 30 or 45 caste angle.

Step 4. Install the new hard drive on your laptop. Slide the new hard drive in at an angle merely like the way yous have it out and push information technology firmly into place where the old hard drive is located, so it'southward fully connected to the interface. And then, secure the difficult bulldoze with removed screws before and put back the laptop panel.

Step 5. Reboot your laptop figurer from the new hard drive.

That'southward all the booting procedure of reckoner step by step with picture, y'all may already starting time computer from the new difficult drive. But if the cloned or restored hard drive won't boot, you could check the given solutions in previous link so try them one by 1. Also, if there are any problem related to our product or technical issues, y'all could contact us via [email protected]

georgeexpea1959.blogspot.com

Source: https://www.ubackup.com/articles/boot-computer.html

Share this post